Requirements for valve installation in distribution boxes

DESIGN STANDARDS AND INSTALLATION REQUIREMENTS

The Design Standards and Installation Requirements (“Standards”) are promulgated by the Engineer in Charge (“Engineer”) of the Los Angeles Department of Water and Power (LADWP)

Section 02440

Submit manufacturer''s certification that plastic meter boxes meet requirements of Paragraph 2.5, Plastic Meter Boxes. Provide approved Type A, cast-iron/ductile-iron, slide-type, valve boxes. Design of

49 CFR 192.747 -

§ 192.747 Valve maintenance: Distribution systems. (a) Each valve, the use of which may be necessary for the safe operation of a distribution system, must be checked and serviced at intervals not

Valve Boxes for Mechanical Utility Systems

Cast-in-place concrete valve boxes are preferred; precast concrete valve boxes have resulted in undesirable coordination and installation challenges (e.g. difficulties in alignment of pipe

GDVI-XX: DISTRIBUTION VALVE INSTALLATIONS INDEX | NV

COAT ALL STEEL PIPE AND VALVE WITH CURRENT APPROVED COATING. INSTALL EXTENSION VALVE INDICATOR (#430035) IF VALVE IS AT AN EXCESSIVE DEPTH THAT WILL REQUIRE IT.

MAINTENANCE STANDARDS

GENERAL: The scope of this document is to provide instruction for the installation and testing of domestic water valves.

SFS Enclosure Systems SFS